Five Steps To Install An LED Tube

LED Tube

Are you ready to replace your fluorescent light bulbs with LED?

On the subject of energy-efficient lighting electricians and light designers know that LED, which stands for light-emitting diode, are on best on the hierarchy. Like fluorescents along with other bulbs, LED lamps come in distinct wattages. But for typical vibrant lighting, you may go for higher output T8 22 watt tubes.

Installation is relatively quick. Nonetheless, it is vital that the ballast on the fixture you use is configured specifically for LED. Keep in mind: you could in no way place LED lamps in fluorescent fixtures, and vice versa. For this purpose, you could possibly need to take away the ballast to adjust the wirings. To accomplish this, comply with this step-by-step process.

Step 1: Make sure that the power is turned off to prevent electric shock accidents during installation. Once that is certainly performed, you’ll need to bypass the electronic ballast. You do these by connecting all the tubes stored wires to neutral and the other 1 to line voltage. While you happen to be essential to hook up the best set of wires for the right place, it is possible to place the tubes either way after you have completed this step.

Step 2: Now that you have bypassed the electronic ballast by following the earlier step, you now proceed to checking it. By now you may have got your line voltage neutral and ground coming via your fixture. The ground is hooked as much as a particular chopper/nut. It is possible to take it from one of several tubes next for the chopper/nut and hook it to all the wires that come from one finish of the fixtures. These is going to be assigned for the neutral. Trace the line coming into the node, and each of the line fixtures coming out of its other side will serve as your line voltage for hot. Using a T8 LED tube, provided that you’ve got effectively assigned the wires (one side for neutral and the other one hot) adequately, it is possible to put the tubes in either way.

Step 3: Before you spot the fixture back together, you’ll need to verify 1st if all the wiring connections are operating correct. To accomplish this location 1 LED tube and turn the energy back on. If it lights up, then it truly is functioning. Soon after this, turn the energy off once more just before you put the cover plate back in place.

Step 4: The last step before putting all of the T8 LED tubes should be to put a sticker or label around the plate. It indicates that the fixture has been adjusted to especially accommodate LED tubes. This permits electricians who will replace the tubes in the future to understand which fixtures could be employed for which distinct tubes. When a fixture has been adjusted for LED, it may no longer be used for fluorescent or other kinds of tubes. See to it that the label/sticker is on the center of your plate or any other spot where it could effortlessly be spotted.

Step five: Now spot all the tubes as well as other labels/stickers (containing the same indication) within the light box. The entire process will take up about 3-5 minutes. Once you have completed this step, you’ll be able to place the cover back on. Test all of your lamps by turning around the switch.

Leave a Reply

Your email address will not be published. Required fields are marked *